Storing The Header - MacDon FlexDraper FD1 Series Operator's Manual

3.13 Storing the Header

Perform the following procedures at the end of each operating season:
CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
and/or flammable.
CAUTION
Cover cutterbar and knife guards to prevent injury from accidental contact.
1. Clean the header thoroughly.
2. Store the machine in a dry, protected place if possible. If storing outside, always cover with a waterproof canvas
or other protective material.
NOTE:
If storing the machine outside, remove the drapers and store them in a dark, dry place. If not removing the
drapers, store the header with the cutterbar lowered so water and snow will not accumulate on the drapers.
The weight of water and snow accumulation puts excessive stress on the drapers and header.
3. Lower the header onto blocks to keep the cutterbar off the ground.
4. Lower the reel completely. If stored outside, tie the reel to the frame to prevent rotation caused by the wind.
5. Repaint all worn or chipped painted surfaces to prevent rust.
6. Loosen the drive belts.
7. Lubricate the header thoroughly leaving excess grease on the fittings to keep moisture out of the bearings.
8. Apply grease to exposed threads, cylinder rods, and sliding surfaces of components.
9. Check for worn components and repair as necessary.
10. Check for broken components and order replacements from your Dealer. Immediate repair of these items will
save time and effort at the beginning of next season.
11. Replace or tighten any missing or loose hardware. Refer to
214683
OPERATION
8.1 Torque Specifications, page
306
577.
Revision A