MacDon FlexDraper FD1 Series Operator's Manual page 386

8. Place the cover (A) on the float module receptacle.
9. Remove the locking pin (A) from the float module
pin (B).
10. Raise the handle (C) to disengage the float module
pins (B) from the feeder house.
11. Replace the locking pin (A) in the float module pin, and
secure with the hairpin.
12. Lower the feeder house until the feeder house posts (A)
disengage the float module (B).
13. Back the combine away slowly from the float module.
214683
HEADER ATTACHMENT/DETACHMENT
362
A
Figure 4.117: Float Module
C
Figure 4.118: Feeder House Locks
A
Figure 4.119: Header on Combine
A
B
B
Revision A