Installing Crop Dividers Without Latch Option Onto Header - MacDon FlexDraper FD1 Series Operator's Manual

9. Pull the tip of the crop divider to ensure there is no
lateral movement. If necessary, adjust bolts (A) to
tighten crop divider and eliminate lateral movement.
10. Close or install endshields. Refer to
page 33.

Installing Crop Dividers without Latch Option onto Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator's manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator's manual for instructions.
4. Open or remove endshields. Refer to
5. Remove crop divider from storage location by lifting
crop divider to disengage lugs (A) at lower end and then
lowering it slightly to disengage pin (B) from endsheet.
214683
OPERATION
3.2.3 Endshields,
Figure 3.140: Crop Divider
3.2.3 Endshields, page
Figure 3.141: Stored Crop Divider
118
33.
A
B
A
Revision A