2. Install bearing lock collar (A) onto the shaft.
3. Using a hammer and punch, tap the bearing lock in the
direction of auger rotation to lock.
4. Tighten bearing lock setscrew (B).
5. Tension the feed draper. Refer to
Draper Tension, page
5.10.4 Feed Draper Idler Roller
This roller is non-powered on the feed draper.
Removing Feed Draper Idler Roller
1. Engage the feeder house safety props.
2. Loosen jam nut (A) and turn bolt (B) counterclockwise
to release the draper tension. Repeat at the
opposite side.
3. Remove nuts and screws (A), and remove the draper
connector straps (B).
4. Open feed deck pan.
214683
MAINTENANCE AND SERVICING
5.10.2 Adjusting Feed
468.
B
Figure 5.162: Feed Draper Drive Roller Bearing
Figure 5.163: Feed Draper Tensioner
A
Figure 5.164: Draper Connector
475
A
B
B
A
Revision A