MacDon FlexDraper FD1 Series Operator's Manual page 291

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Calibrating Maximum Stubble Height

This procedure describes how to calibrate the area counter to stop or start counting at the correct height. Program

the header to a height that will never be reached while cutting. The area counter will stop counting when the header

is above the programmed height, and will begin counting when the header is below the programmed height.

Select the height of the header that corresponds to the description above.

• If the value is set too low, area may NOT be counted since the header is sometimes raised above this threshold

although the combine is still cutting.

• If the value is set too high, the area counter will keep counting even when the header is raised (but below this

threshold) and the combine is no longer cutting crop.

Check to be sure all bystanders have cleared the area.

1. Select the MAXIMUM STUBBLE HEIGHT calibration

dialog box. As you proceed through the calibration

process, the display will automatically update to show

the next step.

2. Move header to the correct position using the header up

or down control switch on the multifunction handle.

3. Press ENTER to continue. As you proceed through the

calibration process, the display will automatically

update to show the next step.

4. Press ENTER or ESC to close the calibration screen.

The calibration is now complete.

Figure 3.469: New Holland Calibration

Figure 3.470: New Holland Calibration

Troubleshooting