MacDon FlexDraper FD1 Series Operator's Manual page 398

8. Remove two bolts (A) and fillers (B) from the transition
pan support angle (C). Repeat on opposite side.
9. Remove screw (A).
10. Remove the 9/16 in. nut from bolt (B).
11. Use a 24 mm (15/16 in.) wrench on hex bolt (C) to
rotate latch downwards and slightly raise the feed deck
to remove bolt (B).
12. Rotate the latch (C) up and back to lower the float
module deck and disengage the transition pan tube.
13. Reinstall screw (A).
14. Repeat for opposite side of the feed draper deck.
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
15. Disengage the reel safety props, start the engine, lower
the reel, and fully raise the header.
16. Stop the engine, remove the key from the ignition, and
engage the combine safety props.
214683
HEADER ATTACHMENT/DETACHMENT
374
B
C
A
Figure 4.144: Fillers
A
Figure 4.145: Float Module Latch
B
C
Revision A