Draper Deck Drive Roller - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Installing Header Draper Idler Roller

1. Position the stub shaft into the idler roller in the forward

arm (B) on the deck.

2. Push on the roller to slightly deflect the forward arm so

the stub shaft at the rear of the roller can be slipped into

the rear arm (C).

3. Install bolts (A) with washers, and torque to 93 Nm

(70 lbf·ft).

4. Wrap the draper over the idler roller, close the draper,

and set the tension. Refer to

Drapers, page

5. Run the machine and verify the draper tracks correctly.

Adjust the draper tracking if required. Refer to

Adjusting Header Draper Tracking, page

Draper Deck Drive Roller

Removing Side Draper Drive Roller

To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine

and remove key before leaving the operator's seat, and always engage safety props before going under

the machine for any reason.

If the draper connector is not visible, engage the header until the connector is accessible (preferably close to the

outboard end of the deck).

1. Start the engine, raise the header, and raise the reel.

2. Shut down the combine, and remove the key from the

3. Loosen the draper by turning the adjuster bolt (A)

counterclockwise.

MAINTENANCE AND SERVICING

5.14.2 Installing Side

Figure 5.207: Idler Roller

Figure 5.208: Draper Tensioner