MacDon FlexDraper FD1 Series Operator's Manual page 441

4. Push the grease fitting (A) back into the guard.
5. Assemble the driveline.
NOTE:
The splines are keyed to align the universals. Align
weld (A) with the missing spline (B) when assembling.
6. Position the combine end of the driveline (A) on the
power take-off (PTO) storage support (B). Pull back the
collar (C) on the driveline and slide driveline onto the
support until the driveline yoke (D) locks onto support.
Release collar (C).
214683
MAINTENANCE AND SERVICING
Figure 5.44: Driveline Guard
Figure 5.45: Driveline
Figure 5.46: Combine End of Driveline
417
A
A
A
D
C
B
B
Revision A