MacDon FlexDraper FD1 Series Operator's Manual page 326

10. Lock the wheel (A) with pin (B). Move the right axle (C)
to the front of the header.
11. Remove the pin (A), raise support (B) to the position
shown, and reinsert pin.
IMPORTANT:
Ensure the pin (A) engages the tube on the axle.
12. Swing the brace (C) into the position shown and insert
the brace into the slot (D) behind the cutterbar. Position
the brace so that pin (E) engages the hole in the
bracket (F). The right wheel is now in transport position.
13. Disengage the header cylinder lift stops.
14. Detach the header's hydraulic and electrical
connections from the combine. Refer to
Attachment/Detachment, page
15. Start the combine and lower the header to the ground.
214683
OPERATION
4 Header
307.
302
C
A
Figure 3.536: Right Rear Wheel
B
A
Figure 3.537: Right Rear Wheel Position
B
F
D
E
C
Revision A