MacDon FlexDraper FD1 Series Operator's Manual page 299

3. Simultaneously press both the UNLOAD (A) and
RESUME (B) buttons on the control handle.
NOTE:
Software in some New Holland combines may not allow
you to change the header from FLEX to PLATFORM or
the header type from DEFAULT to 80/90 at the main
menu. This is now a dealer setting, and requires you to
access the DEALER SETTING screen by pressing and
holding both the UNLOAD and RESUME buttons on the
control handle for approximately 10 seconds. The
DEALER SETTING screen should appear and will allow
you to change the header and header type settings.
4. Select HEAD 1 (A). The HEADER SETUP 1 screen
displays.
5. Select the CUTTING TYPE drop-down arrow (B) and
change the CUTTING TYPE to PLATFORM (C).
6. Select the HEADER SUB TYPE drop-down arrow (A).
The HEADER SUB TYPE dialog box displays.
214683
OPERATION
Figure 3.483: New Holland Combine Controls
Figure 3.484: New Holland Combine Display
Figure 3.485: New Holland Combine Display
275
A
B
C
B
A
A
Revision A