Setting Up Automatic Header Controls (Gleaner S9 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

4. The CALIBRATION WIZARD opens and displays a

hazard message warning screen.

5. Make sure to meet all the conditions listed on the

CALIBRATION WIZARD warning screen. Press the

green check mark to accept and start reel calibration.

Pressing the red X will cancel the calibration procedure.

6. A message appears in the CALIBRATION WIZARD

stating that reel calibration has started. The reel will

begin turning slowly and increase to high speed. A

progress bar is provided. If necessary, touch the red X

to cancel. Otherwise, wait for the message that reel

calibration has completed successfully. Touch the green

check mark to save the calibrated settings.

Setting up Automatic Header Controls (Gleaner S9 Series)

Automatic header functions are configured on the HEADER SETTINGS screen.

Changes may have been made to the combine controls or display since this document was published. Refer to the

combine operator's manual for updates.

Figure 3.291: Calibration Wizard

Figure 3.292: Calibration Progress