Claas 600 And 700 Series Combines; Calibrating The Auto Header Height Control (Claas 600 And 700 Series) - MacDon FlexDraper FD1 Series Operator's Manual

9. Press and hold button (A) or button (B) for 3 seconds to
store the setting into the CEBIS (an alarm will sound
when the new setting has been stored).
NOTE:
Whenever button (A) or button (B) is pressed for
3 seconds, the current positions for reel speed and
cutting height are stored.

3.8.14 CLAAS 600 and 700 Series Combines

Calibrating the Auto Header Height Control (CLAAS 600 and 700 Series)

For best performance of the auto header height control (AHHC), perform these procedures with the center-link set
to D. When setup and calibration are complete, adjust the center-link back to desired header angle. Refer to
Header Angle, page 81.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for
calibration procedure so header doesn't separate from the float module.
1. Ensure center-link is set to D.
2. Ensure that the header float is unlocked.
3. Place wings in locked position.
4. Use control knob (A) to highlight the AUTO CONTOUR
icon (B) and press control knob (A) to select it.
214683
OPERATION
A
Figure 3.435: CLAAS Control Handle Buttons
Figure 3.436: CLAAS Combine Display,
Console, and Control Handle
251
B
B
A
3.7.5
Revision A