Operating In Rigid Mode - MacDon FlexDraper FD1 Series Operator's Manual

NOTE:
The following steps are only required if the above has not worked.
3. Remove the linkage cover. Refer to
Covers, page 37.
4. Retrieve the supplied torque wrench (A) that is stored
on the float module frame on the right side.
5. Place the torque wrench (A) on bolt (B) and use it to
move the wing until the lock disengages.
6. Replace the torque wrench (A) and reinstall the
linkage cover.
7. If necessary, balance the wing. Refer to
and Adjusting Header Wing Balance, page

Operating in Rigid Mode

The three sections will be locked and operate as a rigid cutterbar.
Lock the wings as follows:
1. If the lock link does not engage, move the wing by raising and lowering the header, changing the header angle,
or driving the combine until it engages.
214683
OPERATION
Removing Linkage
Figure 3.48: Torque Wrench
3.7.4 Checking
73.
Figure 3.49: Torque Wrench on Wing Nut
71
A
B
Revision A
A