Calibrating Reel Height Sensor (Claas 600 And 700 Series) - MacDon FlexDraper FD1 Series Operator's Manual

Calibrating Reel Height Sensor (CLAAS 600 and 700 Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
To calibrate reel height, follow these steps:
1. Place header off the ground 15–25 cm (6–10 in.).
2. Use control knob (A) to highlight the FRONT
ATTACHMENT icon (B) and press control knob (A) to
select it.
3. Use control knob (A) to highlight the REEL icon (B), and
press control knob to select it.
214683
OPERATION
Figure 3.450: CLAAS Combine Display,
Console, and Control Handle
Figure 3.451: CLAAS Combine Display and
Console
258
B
A
B
A
Revision A