MacDon FlexDraper FD1 Series Operator's Manual page 318

4. Place the inner end of the inner half of the tow-bar into
the cradle (A) on the right side of the header backtube.
5. Secure the tube end of the tow-bar in support (B) on the
endsheet using clevis pin (C). Secure with hairpin.
6. Install the rubber strap (D) on the cradle (A).
7. Attach the header to the combine. Refer to the combine operator's manual for instructions.
IMPORTANT:
Carrying the tow-bar on the header will affect the main header float. Refer to the combine operator's manual for
adjustment procedures.
8. Place the transport wheels into field position. Refer to the following:
•
Moving Front (Left) Wheels into Field Position, page 295
•
Moving Rear (Right) Wheels into Field Position, page 296
214683
OPERATION
Figure 3.519: Tow-Bar Storage – Right Side
294
D
A
B
C
Revision A