Crop Dividers; Removing Crop Dividers With Latch Option From Header - MacDon FlexDraper FD1 Series Operator's Manual

3.7.13 Crop Dividers

Crop dividers are used to help divide the crop when harvesting. They are removable to allow installation of vertical
knives and to decrease transport width.

Removing Crop Dividers with Latch Option from Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator's manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator's manual for instructions.
4. Open or remove endshields. Refer to
5. Lift safety lever (A).
6. Hold onto crop divider (B), push lever (C) to open latch,
and lower crop divider.
7. Lift crop divider off endsheet and store as follows:
a. Insert pin (A) on crop divider into hole in endsheet
at location shown.
b. Lift crop divider and position lugs (B) on crop
divider into bracket on endsheet. Ensure lugs
engage bracket.
8. Close or install endshields. Refer to
page 33.
214683
OPERATION
3.2.3 Endshields, page
Figure 3.135: Crop Divider
3.2.3 Endshields,
Figure 3.136: Stored Crop Divider
115
33.
C
A
B
A
B
Revision A