MacDon FlexDraper FD1 Series Operator's Manual page 365

NOTE:
Your combine feeder house may not be exactly
as shown.
3. Raise the feeder house slightly to lift the header,
ensuring the feeder house saddle (A) is properly
engaged in the float module frame.
4. Stop the engine and remove the key from the ignition.
5. Use the lock handle (B) to engage lugs (A) with the float
module.
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
214683
HEADER ATTACHMENT/DETACHMENT
341
Figure 4.69: AGCO Group Alignment Pins
Figure 4.70: Feeder House and Float Module
Figure 4.71: AGCO Group Feeder House
C
A
B
A
Revision A