MacDon FlexDraper FD1 Series Operator's Manual page 183

12. Press HEAD2 at bottom of page.
13. Ensure HEADER TYPE is DRAPER.
NOTE:
If recognition resistor is plugged in to header harness,
you will not be able to change this.
14. Set cutting type to PLATFORM.
15. Set appropriate HEADER WIDTH and
HEADER USAGE.
16. From the REEL HEIGHT SENSOR menu, select
YES (A).
17. Locate the AUTOTILT field (A).
•
If using a two-sensor system: Select YES in the
AUTOTILT field.
•
If using a single-sensor system: Select NO in the
AUTOTILT field.
NOTE:
If float was set heavier to complete the AHHC
calibration procedure, adjust to recommended
operating float after the calibration is complete.
214683
OPERATION
Figure 3.230: Case IH Combine Display
A
Figure 3.231: Case IH Combine Display
Figure 3.232: Case IH Combine Display
159
A
Revision A