MacDon FlexDraper FD1 Series Operator's Manual page 517

5. Lift the front edge of draper (A) past cutterbar (B) to
expose the deck support.
6. Measure and note the thickness of the draper belt.
7. Loosen the two lock nuts (A) on deck support (B) ONE
HALF-TURN ONLY.
NOTE:
The number of deck supports (B) is determined by the
header reels: four on single-reel headers, and eight on
double-reel headers.
8. Tap deck (C) to lower the deck relative to the deck
supports. Tap deck support (B) using a punch to raise
the deck relative to the deck supports.
9. To create a seal, adjust deck (A) so that clearance (B)
between cutterbar (C) and deck is 1 mm (1/16 in.) plus
the draper thickness as measured in Step
10. Tighten deck support hardware (D).
11. Recheck gap (B). Refer to Step
12. Tension the draper. Refer to
Tension, page 488.
214683
MAINTENANCE AND SERVICING
6, page 493.
9, page 493.
5.14.3 Adjusting Draper
493
B
Figure 5.197: Deck Adjustment
B
C
Figure 5.198: Deck Support
C
D
Figure 5.199: Deck Support
A
A
A
B
Revision A