MacDon FlexDraper FD1 Series Operator's Manual page 377

5. Store the driveline (A) on the driveline support
bracket (B) by pulling back the collar (C) on the driveline
and fitting it over the support bracket weldment (D).
Release the collar so it locks into place over the
weldment.
6. Lift the handle (A) on the float module.
7. Disconnect the harness (A) from the combine
connector.
8. Remove the lynch pin (B) and slide the lock (C) to
release the handle (D).
9. Lift the handle (D) to full vertical position to release the
multicoupler (E) from the combine.
214683
HEADER ATTACHMENT/DETACHMENT
353
A
Figure 4.96: Driveline
A
Figure 4.97: Multicoupler Storage
C
B
D
Figure 4.98: Multicoupler
B
D
C
E
A
Revision A