Moving Front (Left) Wheels Into Field Position - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

Moving Front (Left) Wheels into Field Position

To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,

remove key, and engage safety props before going under header for any reason.

1. Raise the header fully and engage the header

safety props.

2. Swivel the front wheel assembly (A) so the wheels are

aligned with the lower frame.

3. Remove pin (B) and pull the wheel assembly towards

the rear of header. Store the pin in hole (C) at the top of

4. Pull handle (D) upwards to release and lower the

linkage into the vertical support.

5. Align lift hook (A) with lug (B) and lift the wheel

assembly to engage the pin in the lift hook. Ensure

latch (C) is engaged.

6. Install clevis pin (D) and secure to the center of the axle

with hairpin.

Figure 3.520: Front Wheels

Figure 3.521: Front Wheels