Adjusting Header Draper Tracking - MacDon FlexDraper FD1 Series Operator's Manual

5.14.4 Adjusting Header Draper Tracking

The draper tracking is adjusted by aligning the drive and idler draper rollers.
CAUTION
To avoid personal injury, before servicing machine or opening drive covers, refer to
for Servicing, page 383.
NOTE:
The images shown in the following procedure are applicable to the left draper deck. Use opposite views for the right
draper deck.
Figure 5.192: Draper Tracking Adjustments
Y
B
A - Drive Roller
X - Drive Roller Adjust
1. Refer to the following table to determine which roller requires adjustment and which adjustments are
necessary.
Table 5.2 Header Draper Tracking
Tracking
Backward
Forward
214683
MAINTENANCE AND SERVICING
B - Idler Roller
Y - Idler Roller Adjust
At Location
Drive roller
Drive roller
490
Z
Z - Draper Direction
Adjustment
Increase X
Decrease X
5.1 Preparing Machine
A
X
Method
Tighten nut (E). Refer to Fig.
5.193, page 491
Loosen nut (E). Refer to Fig.
5.193, page 491
Revision A