MacDon FlexDraper FD1 Series Operator's Manual page 545

Tine tube support (if installed) bushings
20. Position the bushing halves (B) on the tine tube (A) with
the flangeless end adjacent to the tine tube arm, and
position the lug in each bushing half into the hole in the
tine tube.
21. On each reel, there are three right-facing supports (A).
Slide the support onto the bushing (B).
22. On each reel, there are two left-facing supports (A).
Rotate the support (A) until its flanges clear the
channels (C) before moving the support onto the
bushing (B).
NOTE:
If necessary, move the tine tube (D) slightly away from
the reel to allow the support flange enough room to
clear the channel.
214683
MAINTENANCE AND SERVICING
Figure 5.261: Cam End
Figure 5.262: Support
Figure 5.263: Opposite Support
521
A
B
A
C
B
B
A
D
Revision A