New Holland Combines (Cr/Cx Series-Pre-2015 Model Year); Checking Voltage Range From The Combine Cab (New Holland) - MacDon FlexDraper FD1 Series Operator's Manual

2. Use control knob (A) to select the AUTO REEL HEIGHT
icon (B) at the top of the page.
NOTE:
The AUTO REEL HEIGHT icon (C) at the center of the
page should be highlighted black. If it is not black, either
the end stops have not been set or the AHHC is not
active. For instructions, refer to
Sensor (CLAAS 600 and 700 Series), page
3. Adjust the auto reel height position for the current
AHHC position using the outer scroll knob (A). To lower
the preset reel position, turn the scroll knob
counterclockwise; to raise the preset reel position, turn
the scroll knob clockwise. The display will update the
current setting (B).
NOTE:
If the AUTO REEL HEIGHT icon in the center of the
page is not black, an AHHC position is not currently
active.
3.8.15 New Holland Combines (CR/CX Series—Pre-2015 Model Year)
This section applies only to pre-2015 CR/CX models. For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and
10.90, refer to 3.8.16 New Holland Combines (CR Series—Model Year 2015 and Later), page

Checking Voltage Range from the Combine Cab (New Holland)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
Series—Model Year 2015 and Later), page
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 150 mm (6 in.) above the ground, and unlock the float.
214683
OPERATION
Calibrating Reel Height
258.
271.
261
C
B
Figure 3.457: CLAAS Combine Display and
Console
Figure 3.458: CLAAS Combine Display and
Console
3.8.16 New Holland Combines (CR
A
B
A
271.
Revision A