Specifications - MacDon FlexDraper FD1 Series Operator's Manual

2.2 Specifications

The following symbol and letters are used in Table
| FD1 | FM100 | Attachments
S: standard / O : optional (factory installed) / O
F
Table 2.1 Header Specifications
Cutterbar
Effective cutting width (distance between crop divider points)
9.1 m (30 ft.) header
10.7 m (35 ft.) header
12.2 m (40 ft.) header
13.7 m (45 ft.) header
Cutterbar lift range
Knife
Single-knife drive (all sizes): hydraulic motor to C-belt to enclosed heavy-duty (MD) knife drive box.
Double knife drive (12.2 and 13.7 m [40 and 45 ft.]): two hydraulic motors to C-belts, untimed, to enclosed
heavy-duty (MD) knife drive boxes.
Knife stroke
Single-knife speed (strokes per minute)
Single-knife speed (strokes per minute)
Single-knife speed (strokes per minute)
Double-knife speed (strokes per minute)
Knife Sections
Over-serrated / solid / bolted / 3.5 serrations per cm (9 serrations per inch)
Knife overlap at center (double-knife headers)
Guards and Hold-Downs
Guard: pointed / forged / double heat treated (DHT)
Hold-down: sheet metal / adjustment bolt
Guard Angle (Cutterbar on Ground)
Center-link retracted
Center-link extended
Draper (Conveyor) and Decks
Draper width
Draper drive
1. Under normal cutting conditions, knife speed taken at the knife drive pulley should be set at 600 rpm
(1200 spm). If set to low end of the speed range, you could experience knife stalling.
214683
PRODUCT OVERVIEW
2.1, page 21 and Table
: optional (dealer installed) / –: not available
D
9.1 m (30 ft.)
1
1 10.7 m (35 ft.)
1 12.2 m (40 ft.)
1 12.2, 13.7 m (40, 45 ft.)
21
2.2, page 23:
914.4 cm (360 in.)
10.668 m (420 in.)
12.192 m (480 in.)
13.716 m (540 in.)
Varies with combine model
76 mm (3 in.)
1200–1400 spm
1100–1300 spm
1050–1200 spm
1100–1400 spm
3 mm (1/8 in.)
2.0 degrees
7.4 degrees
1.057 m (41-19/32 in.)
Hydraulic
S
S
S
S
S
O
F
O
F
S
S
S
S
S
S
S
S
S
S
S
S
Revision A