Installing Tall Crop Feed Plates: Under Driven Deflector; Installing Tall Crop Feed Plates: Under Driveline Deflector - MacDon R85 Operator's Manual

Installing Tall Crop Feed Plates: Under Driven Deflector
1. Remove driveline deflector. See
Deflector, page 137.
2. Locate tall crop feed plates from storage. See Section
6.10.1 Locating Tall Crop Feed Plates for Installation,
page 83.
3. Locate feed plate (A) on the disc, ensuring that
hole in feed plate registers on disc. Position plate
approximately as shown and align holes.
IMPORTANT
Feed plate should be located so that when
holes are aligned, the leading edge of the feed
plate (A) is further from the accelerator (B) than
the trailing edge.
4. Install the deflector.
Deflector, page 139.
Installing Tall Crop Feed Plates: Under Driveline Deflector
1. Locate feed plates. See
Plates for Installation, page
2. Lower the header fully.
3. Shut off the engine and remove the key.
4. Open cutterbar door(s). See Section
Doors, page 31.
5. Install feed plate (A) on the disc.
169457
OPERATING THE HEADER
Removing the Driven
See Installing the Driveline
6.10.1 Locating Tall Crop Feed
83.
5.5 Cutterbar
Figure 6.24: RH End
Figure 6.25: RH End Top View
Figure 6.26: LH End Shown
84
Rev. F