1. Remove the securing ring (A), pin (B), and washers
inside the center arm fore-aft support bracket (C).
Retain washers, pin, and ring.
NOTE:
Washers inside center arm support bracket not shown
in illustration at right.
2. Push the reel back until the end of the cylinder (A) lines
up with the aft setting holes (B) (position 1) in the fore-
aft support bracket (C). Position washers (D) on both
sides of the cylinder end (A) inside the support
bracket (C).
3. Insert pin (A) and secure cylinder (B) and washers in
the center arm support bracket (C). Secure pin (A) with
ring (D).
NOTE:
Washers inside center arm support bracket not shown
in illustration at right.
214683
OPERATION
Figure 3.114: Center Reel Arm in Forward
Position
B
Figure 3.115: Center Reel Arm
Figure 3.116: Center Reel Arm in Aft Position
105
C
B
A
A
B
D
C
B
C
A
D
Revision A