Installing Reel Drive Sprocket
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Align the keyway in sprocket (D) with the key on the
motor shaft, and slide the sprocket onto the shaft.
Secure with flat washer (C) and slotted nut (B).
2. Torque slotted nut (B) to 54 Nm (40 lbf∙ft).
3. Install cotter pin (A). If necessary, tighten the slotted
nut (B) to the next slot to install the cotter pin.
4. Install the drive chain (A) onto the drive sprocket (B).
5. Tighten the drive chain. Refer to
Chain, page
528.
6. Replace reel drive cover. Refer to
Cover, page
527.
214683
MAINTENANCE AND SERVICING
Tightening Reel Drive
Installing Reel Drive
531
A
Figure 5.285: Reel Drive
Figure 5.286: Reel Drive
D
C
B
B
A
Revision A