Installing Endshields; Linkage Covers; Removing Linkage Covers - MacDon FlexDraper FD1 Series Operator's Manual

Installing Endshields

1. Guide endshield onto hinge arm (C) and slowly slide it
downwards.
NOTE:
Ensure hinge arm (C) is installed in the outboard hole
on the hinge bracket, as shown in illustration at right.
2. Install self-tapping screw (B).
3. Disengage lock (A) to allow endshield movement.
4. Close endshield. Refer to
NOTE:
Endshields may expand or contract when subjected to
large temperature changes. Top pin and lower latch
bracket positions can be adjusted to compensate for
dimensional changes. Refer to
Endshields, page 35.

3.2.4 Linkage Covers

Plastic covers are attached to the header frame to protect the header wing balance mechanism from debris and
weather.

Removing Linkage Covers

1. Remove screw (A) and lift outboard end of cover (B).
214683
OPERATION
Closing Endshields, page
Checking and Adjusting
A
34.
Figure 3.17: Left Endshield
Figure 3.18: Linkage Cover
37
B
C
C
B
A
Revision A