Adding Oil To Hydraulic Reservoir - MacDon FlexDraper FD1 Series Operator's Manual

5.4.2 Adding Oil to Hydraulic Reservoir

Follow this procedure to top up the oil in the hydraulic reservoir. To change the hydraulic oil, refer to
Oil in Hydraulic Reservoir, page
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Shut down the combine, and remove the key from the
ignition.
2. Clean any dirt or debris from the filler cap (A).
3. Loosen and remove the filler cap (A) by turning it
counterclockwise.
4. Add warm oil (approximately 21°C [70°F]) and fill to the
required level. Refer to this manual's inside back cover
for oil type and specification.
IMPORTANT:
Warm oil will flow through the screen better than cold
oil. Do NOT remove the screen.
5. Reinstall the filler cap (A).
6. Recheck oil level. Refer to
Hydraulic Reservoir, page
214683
MAINTENANCE AND SERVICING
409.
5.4.1 Checking Oil Level in
407.
Figure 5.28: Oil Reservoir Filler Cap
408
5.4.3 Changing
A
Revision A