Converting From Medium Configuration Or Wide Configuration To Ultra Narrow Configuration - MacDon FlexDraper FD1 Series Operator's Manual

4.1.8 Converting from Medium Configuration or Wide Configuration to
Ultra Narrow Configuration
Four kits of either MD #287032or B6400
configuration. Extra hardware is included in these kits. Be sure to use the correct hardware in the correct location to
prevent damage and to maximize performance.
Medium, Wide, and Ultra Narrow auger configurations are
shown at right. When converting to the Ultra Narrow
configuration, existing flightings (A) are removed and new
flightings (B) are installed.
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to 4 Header Attachment/Detachment, page
NOTE:
Some parts have been removed from the illustrations for clarity.
49. MD #287032 is available only through MacDon Parts. B6400 is available only through Whole Goods. Both kits
contain wear-resistant flightings.
214683
HEADER ATTACHMENT/DETACHMENT
49 and some hole-drilling are required to convert to the Ultra Narrow
307.
323
1
A
2
A
3
Figure 4.31: Auger Configurations (Rear View)
1 - Medium Configuration
3 - Ultra Narrow Configuration
A
A
B
B
2 - Wide Configuration
Revision A