Converting From Transport To Field Position; Removing Tow-Bar - MacDon D65 Operator's Manual

3.15.3 Converting from Transport to Field Position

The header needs to be converted back to field position if it was towed to a new location.

Removing Tow-Bar

The transport tow-bar can easily be disassembled and stored on the header.
1. Block the tires to prevent the header from rolling, and
unhook the header from the towing vehicle.
2. Disconnect electrical connector (A) on the tow-bar.
3. Remove pin (B) from the tow-bar, and detach outer
section (C) from inner section (D).
4. Disconnect electrical connector (A) at the front wheel.
5. Remove clevis pin (A) and set aside for reinstallation.
6. Push latch (B) and lift tow-bar (C) from the hook.
Release latch.
7. Install clevis pin (A).
214327
OPERATION
D
Figure 3.84: Tow-Bar Assembly
Figure 3.85: Wiring Connector
B
C
Figure 3.86: Tow-Bar Latch
98
A
B
C
A
A
Revision B