Chapter 7: Cab Display Module; Cab Display Module - Configuration Functions - MacDon M155 Unloading And Assembly Instructions

Chapter 7: Cab Display Module

Although the other procedures in this instruction are intended to be followed in the order in which they are listed, the
sections in this chapter can be referred to in any order according to your specific requirements.
7.1 Cab Display Module – Configuration Functions
Use the cab display module's (CDM) configuration functions to set up the windrower, to change the appearance of the
CDM itself, to enter diagnostic mode, and to calibrate the header sensors.
A
F
E
Figure 7.1: CDM
A - Side Display
D - Menu Item Scroll Forward
Side display: Displays the current revision level of the windrower's operating software.
• Upper line – C### (CDM software revision level)
• Lower line – M### (Windrower control module [WCM] software revision level)
Main display: Displays potential menu items and the current selection.
NOTE:
The current selection will flash.
• Upper line – Menu item
• Lower line – Current selection
Select switch: Pressing this switch along with the PROGRAM switch puts the CDM into programming mode. Press SELECT to
accept the highlighted menu item and to advance the selection to the next item.
262320
D
B - Main Display
E - Menu Item Scroll Backward
203
B
C
C - Select Switch
F - Program Switch
Revision A