Moving Front (Left) Wheels Into Field Position - MacDon D65 Operator's Manual

7. Attach the header to the windrower.
windrower operator's manual for instructions.
IMPORTANT:
Carrying the tow-bar on the header will affect
the main header float. Refer to your windrower
operator's manual for adjustment procedures.
8. Place the transport wheels into field position. Refer to
the following:
• Moving Front (Left) Wheels into Field Position, page
92
• Moving Rear (Right) Wheels into Field Position,
page 93

Moving Front (Left) Wheels into Field Position

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Raise the header fully and engage the header
safety props.
2. Swivel the front wheel assembly (A) so the wheels are
aligned with the lower frame.
3. Remove pin (B) and pull the wheel assembly towards
the rear of header. Store the pin in hole (C) at the top
of the leg.
4. Pull handle (D) upwards to release and lower the
linkage into the vertical support.
147725
OPERATION
Refer to the
Figure 3.77: Front (Left) Wheels
92
Revision A