Moving Front (Left) Wheels Into Field Position - MacDon D65 Operator's Manual

Draper header for self-propelled windrowers
Table of Contents

Advertisement

6. Attach header to windrower.
operator's manual for instructions.
IMPORTANT:
Carrying the tow-bar on the header will affect
the main header float. Refer to your windrower
operator's manual for adjustment procedures.
7. Place transport wheels into field position. Refer to:
Moving Front (Left) Wheels into Field Position, page
93
Moving Rear (Right) Wheels into Field Position,
page 94

Moving Front (Left) Wheels into Field Position

To move the front (left) transport wheels into field position, follow these steps:
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator's manual for instructions regarding the proper use and storage of header safety props.
1. Raise header fully. Engage header safety props.
2. Swivel front wheel assembly (A), so wheels are aligned
with lower frame.
3. Remove pin (B) and pull wheel assembly towards rear
of header. Store pin (B) in hole (C) at top of leg.
4. Pull handle (D) up to release and lower the linkage in
the vertical support.
169899
OPERATION
Refer to windrower
93
Figure 4.77: Front (Left) Wheels
Revision A

Advertisement

Table of Contents
loading

Table of Contents