Moving Front (Left) Wheels Into Field Position - MacDon FlexDraper FD1 Series Operator's Manual

7. Place the inner end of the inner half of the tow-bar into
the cradle (A) on the right side of the header backtube.
8. Secure the tube end of the tow-bar in support (B) on
the endsheet using clevis pin (C). Secure with hairpin.
9. Install the rubber strap (D) on the cradle (A).
10. Attach the header to the combine.
combine operator's manual for instructions.
IMPORTANT:
Carrying the tow-bar on the header will affect
the main header float. Refer to your combine
operator's manual for adjustment procedures.
11. Place the transport wheels into field position. Refer to
the following:
•
Moving Front (Left) Wheels into Field Position, page
212
•
Moving Rear (Right) Wheels into Field Position,
page 214

Moving Front (Left) Wheels into Field Position

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
147831
OPERATION
Figure 3.342: Tow-Bar Storage
Refer to the
212
Revision A