Chapter 8: Installing Options; Installing Tall Crop Dividers - MacDon R113 Unloading And Assembly Instructions

Chapter 8: Installing Options

Install options (if supplied with the shipment) according to the instructions supplied with each kit.

8.1 Installing Tall Crop Dividers

To install the Tall Crop Divider kit (B5800), follow these steps:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine, and remove the key from the ignition.
3. Unpack the Tall Crop Divider kit.
4. Open the cutterbar doors.
5. Remove four bolts (A) from divider (B). Retain the bolts for
reinstallation.
6. Position left divider (B) on the left front corner, and install
with four previously removed bolts (A) and nuts. Tighten
the hardware.
NOTE:
The mounting holes in the rotary disc header should be
vacant. If necessary, remove the fasteners.
7. Repeat Step 5, page 105
side of the header.
8. Close the cutterbar doors.
262300
to Step 6, page 105 on the right
Figure 8.1: Tall Crop Divider – Left Shown, Right
Opposite
B
Figure 8.2: Tall Crop Divider – Left Shown, Right
Opposite
105
A
B
A
Revision A