Crop Dividers; Removing Crop Dividers With Latch Option From Header - MacDon D65 Operator's Manual

4. Turn latch pin (A) counterclockwise using a 3/4 in. wrench
to release the cam disc.
5. Use the wrench on bolt (B) to rotate the cam disc and align
latch pin (A) with the desired cam disc hole position (C)
(1 to 4).
NOTE:
Bolt (B) is positioned through the cam disc (transparent
view shown in illustration for improved clarity).
6. Turn latch pin (A) clockwise to engage and lock the
cam disc.
7. Repeat Steps 4, page 71
IMPORTANT:
Ensure the cam is secured into position before operating
the machine.

3.7.13 Crop Dividers

Crop dividers are used to help divide the crop when harvesting. They are removable to decrease transport width.
Crop dividers are bolted to the header by default, but a latch option is also available.

Removing Crop Dividers with Latch Option from Header

To correctly remove crop dividers with the latch option, follow the recommended removal procedure provided here.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1. Lower the reel.
2. Raise the header fully.
3. Shut down the engine, and remove the key from the ignition.
4. Engage the header safety props. For instructions, refer to your windrower operator's manual.
5. Open or remove the endshields. For instructions, refer to
214327
to 6, page 71 for the opposite reel.
OPERATION
C
Figure 3.55: Cam Disc Positions
3.2.3 Endshields, page
71
A
B
35.
Revision B