Adjusting Reel Cam; Crop Dividers; Removing Crop Dividers With Latch Option From Header - MacDon D65 Operator's Manual

Refer to 3.6.2 Header Settings, page 44

Adjusting Reel Cam

DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Turn the latch pin (A) counterclockwise using a 3/4 in.
wrench to release the cam disc.
2. Use the wrench on bolt (B) to rotate the cam disc and
align the latch pin (A) with the desired cam disc hole
position (C) (1 to 4).
NOTE:
Bolt (B) is positioned through the cam disc
(transparent view shown in illustration for
improved clarity).
3. Turn the latch pin (A) clockwise to engage and lock the
cam disc.
4. Repeat the above procedure for the opposite reel.
IMPORTANT:
Ensure the cam is secured into position before
operating the machine.

3.7.11 Crop Dividers

Crop dividers are used to help divide the crop when harvesting. They are removable to allow installation of vertical
knives and to decrease transport width.

Removing Crop Dividers with Latch Option from Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel, raise header, stop engine, remove key, and engage header safety props. For instructions, refer to
your windrower operator's manual.
2. Open or remove endshields. Refer to
147725
OPERATION
for recommended reel tine pitch in specific crops and crop conditions.
Figure 3.47: Reel Cam Positioner
3.2.3 Endshields, page
67
35.
Revision A