Step 9. Install Crop Dividers - MacDon Harvest Header D65 Assembly Instructions Manual

For self-propelled windrowers

Hide thumbs Also See for Harvest Header D65:

Table of Contents

STEP 9.

INSTALL CROP

DIVIDERS

a. Dividers are stored on inboard side of endsheets.

To remove, support the divider and remove

shipping wire at front end (A), and then remove

bolt (B).

b. Remove bolt and washer at (C).

c. Position crop divider as shown by locating lugs (D)

in slots (E) in endsheet.

169603

UNLOADING AND ASSEMBLY

d. Lift forward end of divider up to endsheet, and

e. Check that divider does not move laterally. Adjust

install washer and bolt at (C).

bolts (E) as required to tighten divider, and

remove lateral play when pulling at divider tip.

Revision B

Table of Contents

D65