Ethernet Connections; Console And Auxiliary Ports - Cisco AS5350XM Installation Manual

Preparing to Connect to a Network
The ISDN connection is regarded as a source of voltage that should be inaccessible to user contact.
Warning
Do not attempt to tamper with or open any public telephone operator (PTO)-provided equipment or
connection hardware. Any hardwired connection (other than by a nonremovable,
connect-one-time-only plug) must be made only by PTO staff or suitably trained engineers.
Statement 23

Ethernet Connections

Two Gigabit Ethernet (GE) RJ-45 ports are located on the rear panel of the universal gateway: GE0 and
GE1 (selectable). To configure the Ethernet ports, see the Cisco AS5350XM and Cisco AS5400XM
Universal Gateways Software Configuration Guide. Both ports use unshielded twisted-pair (UTP) cable
and require Category 5 cable. The maximum segment distance is 328 feet (100 meters).
Note

Console and Auxiliary Ports

The Cisco AS5350XM universal gateway includes an asynchronous serial console port and an auxiliary
port. The console and auxiliary ports provide access to the universal gateway either locally (with a
console terminal) or remotely (with a modem). This section discusses important cabling information to
consider before connecting a console terminal (an ASCII terminal or PC running terminal emulation
software) to the console port, or a modem to the auxiliary port.
Console Port
The Cisco AS5350XM universal gateway includes an EIA/TIA-232 asynchronous serial console port
(RJ-45). Depending on the cable and the adapter used, this port will appear as a data terminal equipment
(DTE) or data communications equipment (DCE) device at the end of the cable. Your universal gateway
arrives with cables and adapters to connect a console terminal (an ASCII terminal or PC running terminal
emulation software) to the console port. To connect an ASCII terminal to the console port, use the RJ-45
rollover cable with the female RJ-45-to-DB-25 adapter (labeled TERMINAL).
To connect a PC running terminal emulation software to the console port, use the RJ-45 rollover cable
with the female RJ-45-to-DB-9 adapter (labeled TERMINAL). The default parameters for the console
port are 9600 baud, 8 data bits, no parity, and 2 stop bits. The console port does not support hardware
flow control.
For detailed information about installing a console terminal, see
Cisco AS5350XM Universal Gateway."
pinouts.
Cisco AS5350XM Universal Gateway Chassis Installation Guide
2-4
UTP cables look like the cables used for ordinary telephones; however, UTP cables meet certain
electrical standards that telephone cables do not. Cables are not included.
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway
Chapter 3, "Installing the
See Appendix C, "Cabling Specifications," for cable and port
OL-6417-02