Front Panel Ports - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Front Panel Ports

Front Panel Ports
The section describes the front panel ports for the SC-SW and SC cards.
Figure 43: SC-SW Front Panel Ports
1
2
3
4
The Shelf-Controller (SC) external ports include:
• 10GE expansion ports: used to expand the internal control Ethernet network to the LCC by connecting
• DB15 connector: Alarm port that uses a standard DB15 connector.
• EIA-232 serial console ports.
• RJ-45 Ethernet management port: RJ-45 copper10/100/1000 Mbps full duplex port.
• USB2.0 port (type A receptacle): used to attach storage device to the FCC. This USB port is used only
• QSFP+ 40GE optical ports: Quad Small-Form-factor Pluggable (QSFP) 40GE ports used for
• SFP+ 10GE optical ports: controls plane connectivity between the FCC and the LCC.
The Switch (SW) external ports include:
• 56 SFP+ 10GE ports: controls the plane connectivity between the FCC and the LCC and two 40GE
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
70
Two 10GE expansion ports (EXP 0 and EXP 1)
DB15 connector alarm port
Two EIA232 serial console ports: (CON 0 and
CON1)
RJ-45 Ethernet management port
through the SW switch ports. The ports are identical in functionality. Each port is capable of 10GE
operation via SFP+ modules. The SFP+ modules supported are: SFP+10GE-L and SFP+10GE-S.
for storage devices.
communication between the FCC and Route Processor (RP) cards on the LCC.
ports.
Installing the Shelf Controller Cards and Fabric Cards
5 USB 2.0 port
6 Two QSFP+ 40GE optical ports (HS0 and HS1)
7 56 SFP+ 10GE optical ports, left to right(0
through 27 on bottom, 28 though 55 on top)