Rep 10.4 Exit Roll And Exit Idler Assemblies - Xerox phaser 3635 Service Manual

1
Remove the
clamp.
4
Remove the front duplex
guide assembly.
Figure 2 Front duplex guide assembly removal
9. If necessary remove the tray 1 paper empty sensor, PL 10.22 Item 1 from the front duplex
guide.
Replacement
1. Replacement is the reverse of the removal procedure.
Draft 4
Phaser 3635MFP

REP 10.4 Exit Roll and Exit Idler Assemblies

Parts List on PL 10.25
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1.
2.
3.
4.
5.
2
6.
Remove 2 screws.
7.
Replacement
3
1.
Disconnect the
connector.
4-33
WARNING
CAUTION
Remove the DADF, PL 5.10 Item 1.
Remove the left cover, right cover and rear cover, REP 28.1.
Remove the UI assembly, REP 2.1.
Remove the scanner assembly, REP 14.1.
Remove the exit cover assembly, PL 28.10 Item 2.
Remove the exit roll, PL 10.25 Item 22.
Remove the idler assembly, PL 10.25 Item 21 if required.
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 10.3, REP 10.4