Rep 10.18 Inverter Output Guide Assembly - Xerox WorkCentre 5790 Series Service Manual

Replacement
The replacement is the reverse of the removal procedure. Refer to
screws to the output guide.
Check that the inverter path solenoid harness is not caught between the nip roll guide and the
support bracket, Figure 4.
Inverter path solenoid harness
Figure 4 Inverter path solenoid harness
Xerox® WorkCentre® 5790 Family
GP 6 before refitting the
CAUTION

REP 10.18 Inverter Output Guide Assembly

Parts List on PL 10.11
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the inverter assembly,
Nip roll
2. Release the nip roll guide,
guide
Support
bracket
3
Lift the guide to release
the nip roll guide
May 2013
4-229
WARNING
GP 14. Disconnect the power cord
WARNING
REP 10.2.
Figure 1.
2
Remove two screws
Figure 1 Release nip roll guide
REP 10.17, REP 10.18
1
Disconnect the
harness
Repairs/Adjustments