Rep 9.2 Xerographic Module Connector And Crum Pwb - Xerox WorkCentre 4150 Service Manual

REP 9.2 Xerographic Module Connector and CRUM PWB

(4150)
Parts List on PL 4.15
Removal
NOTE: This procedure should only be performed on the 4150. For the 4250/4260 procedure,
refer to the table of contents.
For the 4265 procedure, refer to REP 9.6.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the main drive assembly, REP
2. Remove the xerographic module connector,
Repairs and Adjustments
REP 9.2
WARNING
WARNING
CAUTION
GP
4.1.
Figure 1.
10.
January 2016
4-140 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
4
Carefully disconnect the connector.
Figure 1 Connector removal
3
Remove the xerographic
module connector.
2
Remove the connector
holder.
1
Remove 4 screws.