Set Origin - Dell S6000 Reference Manual

Parameters
ip-address
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
If you configure the set next-hop command, its configuration takes precedence
Information
over the neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface's IP address
(either Loopback or physical), the software declares the route unreachable.
Related
match ip next-hop
Commands

set origin

To manipulate the BGP ORIGIN attribute, configure a filter.
S6000
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters
egp
igp
Access Control Lists (ACL)
Specify an IP address in dotted decimal format.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop IP address.
Enter the keyword egp to set routes originating from outside
the local AS.
Enter the keyword igp to set routes originating within the
same AS.
255