Set Level - Dell S6000 Reference Manual

none
additive
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match community
Commands

set level

To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
S6000
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1
| level-1-2 | level-2 | stub-area} command.
Parameters
backbone
250
All routes with the NO_EXPORT (0xFFFFFF01) community
attribute must not be advertised outside a BGP
confederation boundary.
Enter the keyword none to remove the community attribute
from routes meeting the route map criteria.
(OPTIONAL) Enter the keyword additive to add the
communities to already existing communities.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the COMMUNITY attribute.
Enter the keyword backbone to redistribute matched routes
to the OSPF backbone area (area 0.0.0.0).
Access Control Lists (ACL)