Set Weight - Dell S6000 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric
set metric-type

set weight

To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
S6000
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the route type assigned to redistributed routes.
Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
257