Certificate Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
C C
ERTIFICATE
To activate the Certificate Configuration mode, enter the crypto ca certificate chain command at the
Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#crypto ca certificate chain MyProfile
ProCurve(config-cert-chain)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
certificate <serial-number>
certificate ca <serial-number>
crl on page 1226
5991-2114
ONFIGURATION
on page 1224
on page 1225
© Copyright 2006 Hewlett-Packard Development Company, L.P.

Certificate Configuration Command Set

C S
OMMAND ET
on page 1431
1223