Crypto Map Ike Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
C M IKE C
RYPTO AP
To activate the Crypto Map IKE mode, enter a valid version of the crypto map ipsec-ike command at the
Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#crypto map Map-Name 10 ipsec-ike
ProCurve(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1228
ike-policy <policy number>
match address <listname>
reverse-route on page 1234
set peer <address>
set pfs [group1 | group2 | group5]
set security-association lifetime [kilobytes | seconds] <value>
set transform-set <setname1 - setname6>
5991-2114
OMMAND
on page 1434
on page 1231
on page 1232
on page 1235
on page 1236
on page 1238
© Copyright 2007 Hewlett-Packard Development Company, L.P.
S
ET
on page 1237

Crypto Map IKE Command Set

on page 1431
1227